RD11-TS-7B
DESIGN STANDARDS 2-LANE HIGHWAYS WITH CONTINUOUS 2-WAY LEFT-TURN LANE
(Click image to open PDF)
Related Standard Drawings
| DRAWING | DESCRIPTION | REMARKS |
|---|---|---|
| S-CZ-1 | CLEAR ZONE CRITERIA | FOR CLEAR ZONE CRITERIA |
| S-PL-6 | SAFETY PLAN SAFETY HARDWARE PLACEMENT ON OUTSIDE EDGE | FOR TYPICAL GUARDRAIL PLACEMENT |
| S-PL-6A | SAFETY PLAN SAFETY HARDWARE PLACEMENT IN MEDIAN | FOR TYPICAL GUARDRAIL PLACEMENT |
| RD11-S-11 | DESIGN AND CONSTRUCTION DETAILS FOR ROADSIDE SLOPE DEVELOPMENT | FOR FILL AND CUT SLOPE TABLES. ROUNDIN ON TOP OF CUT SLOPES AND TOE ROUNDING ON TOP OF CUT SLOPES AND TOE OF FILL SLOPE SPECIAL ROCK TREATMENT AND SUBGRADE ROUNDING IF APPLICABLE |
| RD11-S-11A | ROADSIDE DITCH DETAILS FOR DESIGN AND CONSTRUCTION | FOR ROUNDING OF ROADSIDE DITCH SLOPES |
| RD11-TS-1 | DESIGN STANDARDS FOR LOW-VOLUME ROADS | TYPICAL SECTION DESIGN FOR VOLUMES LESS THAN 5,000 VEHICLES PER DAY USES THE DESIGN STANDARDS SHOWN |
| RD11-TS-2 | SUPERELEVATION TRANSITION DETAILS FOR UNDIVIDED ROADWAY | TYPICAL SECTION DESIGN FOR VOLUMES LESS THAN 5,000 VEHICLES PER DAY USES THE DESIGN STANDARDS SHOWN |
| RD11-TS-3 | DESIGN STANDARD FOR ARTERIAL HIGHWAYS (2-LANE) | TYPICAL SECTION DESIGN FOR VOLUMES LESS THAN 5,000 VEHICLES PER DAY USES THE DESIGN STANDARDS SHOWN |
| RD11-TS-SERIES | RD11 TYPICAL SECTION AND DESIGN CRITERIA | FOR TYPICAL SECTION REQUIREMENTS |
| T-M-1 | DETAILS OF PAVEMENT MARKINGS FOR CONVENTIONAL ROADS AND MARKING ABBREVIATIONS | SEE STRIPING DETAILS |
Related Item Numbers
| ITEM NO. | U/M | DESCRIPTION | REMARKS |
|---|---|---|---|
Archived Standard Drawings
| DATES OF EACH ARCHIVED DRAWINGS ( THE INITIAL STANDARD DRAWING IS BOLD ) |
|---|
| 01-01-2019 | 07-17-2020 |
If you find any mistakes, missing information or have a question, contact:
TDOT CADD Support
1200 James K. Polk Building
Nashville, TN 37243-1402
TDOT.CADDSupport@tn.gov
This Page Last Updated: September 11, 2020 at 11:31 AM